Bosch MUM5X GB Series, User Manual

Page: 16 / 112

en
Familiarising yourself with your appliance
16
1.
Hold the beating whisk at the bot-
tom with one hand and release the
lock nut clockwise using a spanner
wrench.
→ Fig.
4
2.
To change the distance, turn the
tool.
→ Fig.
5
Observe the values in the table:
Setting Distance
Optimum setting 3 mm
One turn clockwise 1 mm more
One turn anticlock-
wise 1 mm less
3.
Press the release button and push
the swivel arm down until it en-
gages.
4.
Check the setting.
5.
Press the release button and raise
the swivel arm until it engages.
6.
Hold the beating whisk at the bot-
tom with one hand and tighten the
lock nut anticlockwise using a
spanner wrench.
Symbols
You can find an overview of the sym-
bols used on your appliance here.
Symbol Description
Marking on the protective cover
for drive 2.
Attachment marking on the pro-
tective cover for drive 3.
Position marking on drive 3.
Parked position
Your appliance is equipped with an
automatic parked position.
After the appliance has switched off,
the drives will continue moving for a
few seconds until the correct parked
position is reached.
Note:
The swivel arm will only open
or close with the inserted tool when
the drive is located in the correct
parked position.
The following causes result in an
incorrect parked position:
¡
The power supply was interrupted
during processing.
¡
A safety system terminated pro-
cessing.
¡
During processing the swivel arm
disengaged or the release button
for the swivel arm was pressed.
Tip:
You can easily adjust an incor-
rect parking position yourself.
→
"Troubleshooting", Page 25
Safety systems
You can find an overview of your ap-
pliance's safety systems here.
Start lock-out
Start lock-out prevents your appli-
ance from being switched on acci-
dentally.
The appliance can only be switched on
and operated if
¡
the swivel arm is engaged in posi-
tion 1 and the bowl or an access-
ory is inserted, e.g. Ice maker.
¡
the swivel arm is engaged in posi-
tion 3 and the protective cover or
an accessory is fitted on drive 3.
Restart lock-out
Restart lock-out prevents your appli-
ance from automatically restarting
processing after a power failure.
The appliance is switched on again
after a power failure. Processing can-
not start again until the rotary switch
has been set to
⁠.