MON170CL |
Instruction Manual
|
Safety Precautions
EN
| 3
Bosch Security Systems | 6 July 2005
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
This symbol indicates the presence of
uninsulated “dangerous voltage” within the
product’s enclosure that can cause an
electric shock.
This symbol indicates the presence of
important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
For Indoor Product
1.
Water and Moisture
- Do not use this unit near
water - for example, in a wet basement, in an
unprotected outdoor installation or in any area
classified as a wet location.
2.
Object and Liquid Entry
- Never push objects of
any kind into this unit through openings, as they
might touch dangerous voltage points or create
short circuits, resulting in a fire or electrical shock.
Never spill liquid of any kind on the unit.
3.
Power Cord and Power Cord Protection
- For
units intended to operate with 230VAC, 50Hz, the
input and output power cord must comply with the
latest versions of IEC Publication 227 or IEC
Publication 245.
Power supply cords should be routed so they are
not likely to be walked on or pinched. Pay
particular attention to location of cords and plugs,
convenience receptacles, and the point of exit
from the appliance.
4.
Overloading
- Do not overload outlets and
extension cords; this can result in a risk of fire or
electrical shock.
For Outdoor Product
Power Lines
- An outdoor system should not be
located in the vicinity of overhead power lines,
electric lights or power circuits, or where it may
contact such power lines or circuits. When
installing an outdoor system, extreme care should
be taken to keep from touching power lines or
circuits, as this contact might be fatal. U.S.A.
models only - refer to the National Electrical Code
Article 820 regarding installation of CATV
systems.
For Rack-mount Product
1.
Ventilation
- Do not place this equipment in a
built-in installation or rack, unless proper ventilation
is provided, or the manufacturer's instructions
were followed. The equipment must not exceed its
maximum operating temperature requirements.
2.
Mechanical Loading
- When rack-mounting the
equipment, ensure that a hazardous condition is
not created by uneven mechanical loading.
Cover Removal
WARNING: Removal of the cover should only be
performed by qualified service personnel - not user
serviceable. The unit should always be unplugged before
removing the cover and remain unplugged while the cover
is removed.
Installation should be performed by qualified
service personnel only in accordance with the
National Electrical Code or applicable local
codes.
Power Disconnect. Units with or without
ON-OFF switches have power supplied to the
unit whenever the power cord is inserted into the
power source; however, the unit is operational
only when the ON-OFF switch is in the ON
position. The power cord is the main power
disconnect for all units.
Safety Precautions
