Bosch MIC-67SUNSHLD, Quick Installation Manual

Page: 1 / 26

Install the MIC7000 Sunshield
Parts List
Two (2) Sunshield shells “A”
One (1) Sunshield shell “B” (without vents)
Four (4) M4 x 8 socket head Torx screws
Two (2) M4 x 14 socket head Torx screws
Four (4) M4 flat washers
One (1) Quick Installation Guide
Additional Tools Required
1 Phillips-head screwdriver, #2, to remove
factory-installed plastic screws from the
camera head
1 Torx driver, T20, for M4 Torx head screws
Notice!
If your MIC camera will be canted, in-
stall the sunshield first.
If your MIC camera will have both illu-
minator and sunshield accessories, in-
stall the illuminator first.
Extreme low temperature models do
not support a sunshield.
24 VAC
1. Mount the camera. Apply power. Connect us-
ing a web browser or VMS.
2. Operate the tilt to near the upper limit.
#2 Phillips
3. Remove and discard 4 screws.
A
B
A A
4. Align the sunshield shells so that the pins
slide into the bolt heads on the faceplate.
When attaching to a MIC with an illuminator, use
shell “B” without vents.
A A
2.2 N m
(19.5 in. lb)
M4 x 8
2.2 N m
(19.5 in. lb)
M4 x 8
T20 Torx
5. Ensure that the sunshield mounting holes
align with the holes in the rear of the camera
head. Install 4 screws and washers.
2.2 N m
(19.5 in. lb)
M4 x 8
M4 x 14
2.2 N m
(19.5 in. lb)
B A
T20 Torx
6. Use the longer screws for shell “B”.
3.5 mm ( ≈ 1/8”)
7. If the rear gap is not parallel, rework to en-
sure that the pins are seated properly in the bolt
heads on the faceplate.
1 | 2 | 3 | 4 |
5 | 6 | 7 | 8 |