Bosch MGM6632.IN, Instruction Manual

Page: 8 / 16

8
en Cleaning
Cleaning
W Risk of electric shock!
Never immerse the main unit in water or
any other liquid or pour any liquid over it.
Never hold under running water and do not
clean in the dishwasher.
To keep your Bosch mixer grinder sparkling
clean, just follow these steps.
1.
First remove the mains plug from the
electrical socket.
2. Clean the main unit using a damp/wet
cloth. Do not use abrasive cleaning
agents.
3.
Hold the jar under running water for a
minute after each use to remove the
residue.
4. Please remove active flow breaker while
cleaning the jar. For instructions how to
remove it, please refer to X “How to fit/
remove active flow breaker” see page 6.
5. Remove the jars after each use and
wash in soapy water. Then rinse with
clean water.
6. Dry the parts thoroughly with a clean
soft cloth.
7. Always keep/store the jars upside down.
8. We recommend you clean your Bosch
mixer grinder immediately after use for
easier removal of residue.
9.
Do not immerse the main unit in water
or any other liquid or pour liquid over it.
10. Regularly clean the jars and gaskets
after each use for proper hygiene and
performance of the Mixer Grinder.
11.
After every use of the Mixer Grinder,
pour small amounts of hot water into
the jars to remove the leftover or sticky
substances.
Troubleshooting
Trouble Reason Check
Mixer grinder does not
switch on
No power supply. Check mains supply.
Overloading with
ingredients.
Remove some ingredients, process
smaller quantities.
Overload protection
mechanism is activated.
Press the red reset button on the
bottom of the mixer grinder.
Other than above
mentioned.
Call Bosch service centre.
Time taken for mixing/
blending is very long
Loose blade or wrong
blade selection.
Check blade and choose blade as
per grinding requirements. Tighten
properly with spatula/spanner.
Overloading of mixer. Remove some ingredients, process
smaller quantities.
Unit overheating External heat source. Check and remove any heat
source, if nearby.
Uneven surface that
blocks air vents.
Place the mixer on a level surface.
Overloading with
ingredients.
Remove some of the ingredients
and add in small quantities.
The coupler and/or some
other parts are removed
during removing the blade.
This is normal and may
happen during changing
the blade.
X “Blade changing procedure” see
page 9
.