Bosch MAP Control Center IUI-MAP0001-2, User Manual

Page: 56 / 64

56 en | Operation MAP Control Center
2014.11 | 06 | F.01U.168.328 User Manual Bosch Sicherheitssysteme, GmbH
To test a selected area (or more than one area), press the Motion Test Selected Area button.
The Motion Detector Test screen appears with red "X" marks ( Figure 2.90 Motion Detector Test
screen – Test Mode Off, page 56 ) or green check marks ( Figure 2.91 Motion Detector Test
screen – Test Mode On, page 56 ).
Figure 2.90 Motion Detector Test screen – Test Mode Off
Figure 2.91 Motion Detector Test screen – Test Mode On
If the test mode is On, detectors equipped with this function illuminate their LEDs when they
sense motion.
2.8.7 Bell Test
On the Service menu ( Figure 2.64 Service Menu – screen 2, page 43 ), select Bell Test . The Bell
Test Progress screen( Figure 2.92 Attention: Bell Test in Progress, page 57 ) shows that the bell
test is in progress. During the bell test, the control center's red, amber, and green LEDs light
for three seconds and the speaker emits a short beep. The bell test completes in
approximately three minutes for optical alarms and approximately three seconds for acoustic
alarms. The bell test cannot be disconnected.