Bosch LTE65, Manual

Page: 9 / 28

Installation | 3
Bosch Motorsport Telemetry_System_LTE65_Manual 9 / 28
3.3 Pit Stand Installation
The pit stand antenna available from Bosch Motorsport is a dual 4G MIMO antenna with
3G fallback, both MIMO antennas are in the same housing. This antenna should be in-
stalled in an open location not obstructed by carbon fiber or metal objects.
Pit stand harness specifications
Min Supply Voltage 8 V DC
Max Supply Voltage 18 V DC
Power Consumption 6 W
Power Mating Connector DTM06-2S
Power Mating Connector Pinout 1=Bat Pos, 2=Bat Neg
3.4 Safety Notices
CAUTION
Disconnect power before handling of the antenna.
CAUTION
Keep a minimum safety distance of 5 cm from the human body to
the antenna.
3.5 Antenna Installation
When installing antennas, ensure that you are not spinning the cable or antenna body rel-
ative to the LTE65. To tighten the SMA connection, only turn the collar of the cable or an-
tenna. Spinning the entire cable or antenna can lead to damage of the internal co-ax
cable of the LTE65 and reduced RF performance. It is also recommended to tighten the
SMA connections to 3 in-lbf (0.3 Nm). SMA specific torque wrenches are available from
many retailers.
3.6 Receiver Ethernet Connection
Note that an LTE65 receiver must be plugged directly into a computer and not into a
switch or router. USB to Ethernet adaptors are ok to use with the computer. When the
device is used as a receiver with an Ethernet connection it will act as a DHCP server and
assign an IP to the connected computer. The default configuration for LTE65 IP and DHCP
is 10.10.0.235/24 with a lease range from 10.10.0.65-69.
Static IP addresses are not recommended as the LTE65 receiver may not reliably detect
the IP of the connected laptop.