Bosch LTE65, Manual

Page: 14 / 28

4 | Tools
14 / 28 Telemetry_System_LTE65_Manual Bosch Motorsport
Serial TX Telemetry
To send serial telemetry the TELEMETRY_Mode should be set to Serial. No other changes
are required or values need to be set to specific values. Baudrate can be configured based
on use case needs if required.
Note: With serial to serial configuration, it is recommended that the transmitter transmits
at 57,600 bps and the receiver receives at 115,200 bps.
Note: It is recommended to keep serial bus usage below 80 % when sending serial data.
4.2.3 Configuration of Data Stream
To configure channels to be sent over telemetry, the channels must first exist in the Race-
Con project.
To add channels to be sent over the telemetry system, double-click the LTE65 icon in the
RaceCon project window. This will bring up the LTE65 Configuration Management page.
Channels can be added by single-clicking on the data logs and drag and drop the channel
into the LTE65 window.
‘Fast’ and ‘Slow’ telemetry mode are configurable for each data channel. Shown in the
window below opened by double clicking the channel in the Telemetry Configuration
Measurement window.