LTC 9385 Series |
Instruction Manual
|
Installation
EN
| 14
Bosch Security Systems | January 26, 2005
5.13
Final Assembly
5.13.1 Pull Seal Installation
If the
breather
hole is open, do NOT mount the
housing in a position where the front face
plate is pointed upward.
To maintain enclosure protection ratings of NEMA-4
and IP65, the pull seal (provided in the hardware kit)
must be installed in the front face plate. It is
recommended that the pull seal be installed in a cool,
dry environment to prevent trapping moisture inside
the housing. See FIGURE 14.
NOTE: Pull seal installation allows the housing’s front
end to be pointed upward.
FIGURE 14 Breather Hole
Proper installation of the pull seal is as follows:
1. If the housing assembly is not already removed
from the base assembly, do so now; see the
Disassembly and Mounting
section at the beginning
of these instructions.
2. Obtain a rubber pull seal from the hardware kit
(Part Number 315 2569 001). An extra pull seal
is also provided. See FIGURE 15.
FIGURE 15 Pull Seal
3. Insert the
long end
of the pull seal into the
breather hole starting from the front side of the
face plate. See FIGURE 16.
FIGURE 16 Inserting the Pull Seal
4. Reach into the housing and grip the pull seal’s
long end
from the back of the front face plate.
Steadily pull the
long end
until the head of the
pull seal is flat against the front of the end cap.
See FIGURE 17.
NOTE: The Pull Seal’s
long end
will stretch when
pulled through the breather hole.
FIGURE 17 Installing the Pull Seal
Pull Seal
Face Plate
Housing
Grip and Pull
Housing (cut away)
Front
Face
Plate
Breather Hole
