EN
| 3
Bosch Security Systems | 19 August 2004
FIGURE 1 Installing the Base Tray
NOTES:
•
If the monitor does not have removable feet
(LTC 2917/90 and LTC 2813/60 monitors), align
the pads on the monitor base with the holes
in the base tray. Secure the monitor to the
base with sheet metal screws (not provided);
self-threading sheet metal screws with a
maximum length of 19mm (3/4in.) are
recommended. While attaching the monitor to
base tray, do not push in the plastic stand-offs
protruding from the bottom of the monitor, as
this may damage the monitor’s internal
workings.
•
When installing the LTC 9113/00, use the
front-most set of holes in the base tray so that
the flip-down drawer on the monitor is still
accessible once installed in the rack.
2. Align the two (2) rack side panels with the sides
of the base tray, and attach using the six (6)
supplied 8-32 screws.
FIGURE 2 Attaching the Side Panels
3. Install the unit (monitor, base tray, and 2 rack
side panels) into the rack. If necessary, use the
four (4) supplied 10-32 screws and U-type nut
fasteners.
FIGURE 3 Installing the Unit into the Rack
4. Install the cover bezel using the four (4)
supplied 4-40 machine screws, inserted into
the holes in the rack side panels.
FIGURE 4 Installing the Cover Bezel
LTC 9113/00, LTC 9114/00, LTC 9115/00, LTC 9017/00, LTC 9117/00 |
Instruction Manual
|
Installation
Removable
Feet
Orientation Hole
OSD
A
B
Y/C
SE
Q
4-40 Screws (4)
10-32 Screws (4)
U-Nut (4)
(Optional)
(Monitor Shown
Installed in Rack Kit)
19in. EIA Rack
