Bosch ISW-BDL1-W11PGX, System Reference Manual

Page: 13 / 58

wLSN Discovering and Defaulting a wLSN Device | en 13
Bosch Security Systems, Inc. System Reference Guide F01U138553 | 01 | 2010.05
4.2 Defaulting a wLSN Device
Defaulting a wLSN device returns it to an undiscovered state.
After a device is defaulted, it can be enrolled into a wLSN
network.
Defaulting a Door-Window Contact, Motion Detector, Siren
(ISW-BSR1-WX), Relay Module, or Water Sensor/Low-
Temperature Sensor
1. Remove the batteries.
2. Press and hold the tamper switch button.
3. Reinsert the batteries while holding the tamper switch
button.
The LED on the wLSN device turns on.
4. Release the tamper switch button within five sec after the
LED on the wLSN device turns on.
The LED on the wLSN device briefly turns off and then on,
indicating that the wLSN device was successfully
defaulted.
Defaulting a Glass Break Detector or Siren (ISW-BSR1-WIX
and -WOX)
If the wall tamper tab is removed and you must default the
Glass Break Detector, Indoor Siren (ISW-BSR1-WIX), or
Outdoor Siren (ISW-BSR1-WOX):
1. Remove or disconnect the batteries from the device.
2. Place the device on a flat surface to depress the wall
tamper switch. Refer to Figure 4.1 , and Figure 4.2 on page
Page 14 .
3. Press and hold the cover tamper switch. Refer to
Figure 4.1 , and Figure 4.2, Page 14 .
NOTICE!
When the Inertia Detector is defaulted, its LED briefly turns off
and on, and then the detector enters Test Mode. Refer to
Section 5.7.2 Test Mode, page 33 for more information.
To default a key fob, delete the user from the control panel, and
then re-enter the user without the key fob. Refer to the control
panel documentation for instructions.