6
Photobeam 5000
Setup | en
21
Setup
Turn the Bypass switch on to activate the bypass feature.
3
2
1
Figure 6.1: Receiver Bypass switch
Callout
﹘
Description
1
ー
Receiver
2
ー
Switches (AND/OR GATE switch 4, BYPASS switch 5, and LEVEL CHECK switch 6)
3
ー
Beam interruption time sensitivity volume
AND/OR Gate (on the receiver)
Set the dip switch 4 on the receiver to:
ON: OR GATE
OFF: AND GATE (original position)
BYPASS (on the receiver)
Set the dip switch 5 on the receiver to:
ON: BYPASS activated
OFF: BYPASS not activated (original position)
LEVEL CHECK (on the receiver)
Set the dip switch 6 on the receiver to:
ON: Perform optical alignment of the upper beam
OFF: Perform optical alignment of the lower beam (default position)
Interruption time
Turn the sensitivity control on the receiver clockwise to reduce sensitivity and
counterclockwise to increase sensitivity.
Bosch Security Systems, Inc.
Installation and Operation Guide
2016.02 | 03 | F.01U.303.478
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
