Bosch HSG732155M, Instructions For Installation And Use Manual

Page: 15 / 72

15
Catalytic cooking compartment panels
Only model HSG738155M:
The catalytic cooking compartment panels are coated with self-
cleaning enamel.
The surfaces clean themselves while the oven is in operation.
Larger splashes will only be removed after the oven has been
used several times.
Self-cleaning surfaces
The side walls are covered with catalytic panelling. Never clean
these surfaces with oven cleaner. Slight discolouration of the
enamel does not affect automatic self-cleaning.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
Removing the appliance door
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Make sure that, when unhooking the oven door, the
locking levers are folded up completely.
1. Open the oven door completely.
2. Fold up the left and right locking levers. Make sure that, when
the locking levers are folded up, you do not close the oven
door. The hinges may become bent which may cause
damage to the enamel.
3.
Open the oven door at an angle. Hold it on the right and left
with both hands. Close it just a little further and pull it out.
Fitting the appliance door
1.
When hooking in the oven door, ensure that the notch on the
bottom of the hinge locks into the slot.
2.
Fold down both locking levers on the left and right again and
close the oven door.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call the after
­ sales
service.
Cleaning the hook-in racks
Only model HSG738155M:
You can remove the hook-in racks for easier cleaning.
The hook-in racks are all fixed to the side walls of the cooking
compartment at four points.
Gas hob and pan
supports Hot soapy water.
Use very little water. Water must not be
allowed to enter the appliance through
the base of the burners.
Clean boiled over liquids and spilt food
immediately.
You can remove the pan supports. Do
not clean the pan supports in the dish-
washer.
Gas burners, hot-
plate
Remove the burner cups and caps, clean
them with soapy water.
The gas outlet openings must remain
free from obstruction.
Ignition plugs: small, soft brush.
The gas burners only work properly
when the ignition plugs are clean. Dry all
parts thoroughly. Ensure they are refitted
correctly.
The burner caps are coated in black
enamel. The colour may change over
time. This does not affect their operation.
Enamel surfaces
(smooth surfaces)
For easier cleaning, you can switch on
the cooking compartment lighting and, if
necessary, unhook the appliance door.
Apply a standard washing-up liquid or
vinegar solution using a soft, damp cloth
or chamois leather. Dry using a soft
cloth. Soften any burnt-on food residues
with a damp cloth and washing-up liquid.
If it is very dirty, we recommend oven
cleaner in gel form. This can be applied
to the affected area. Leave the cooking
compartment open after cleaning to
allow it to dry.
Self-cleaning sur-
faces (rough sur-
faces)
Follow the instructions in the section:
Self-cleaning surfaces
Gas burner, oven
and grill
Never clean the gas burners in the cook-
ing compartment yourself.
Door panels Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Glass cover for the
oven light
Hot soapy water:
Clean with a dish cloth.
Seal
Do not remove.
Hot soapy water:
Clean with a dish cloth. Do not scour.
Shelf Hot soapy water:
Soak and clean with a dish cloth or
brush.
Accessories Hot soapy water:
Soak and clean with a dish cloth or
brush.
Area Cleaning agents