Bosch Home Professional BSG8PRO1, Instructions For Use Manual

Page: 18 / 157

full. In this case it is essential to change
the dust bag due to the type of material it
contains.
Open the dust bag compartment lid by
moving the dust compartment locking lever
in the direction of the arrow.
Figure
Seal the MEGAfilt ® SuperTEX dust bag by
pulling the self-seal tap and then remove it.
Figure
Insert a new MEGAfilt ® SuperTEX dust bag
into the holder and close the dust bag com-
partment lid.
!
Caution: the dust bag compartment lid will
only close when the MEGAfilt
® SuperTEX
disposable or textile filter are inserted.
If the dust bag change indicator is still
lit after the dust bag has been changed,
please check whether the nozzle, tube
or flexible hose are blocked.
Cleaning the motor protection filter
The motor protection filter should be cleaned
regularly by knocking out the dirt and rinsing.
Figure
Open the dust bag compartment lid
(see Figure 14).
Pull out the motor protection filter in the
direction of the arrow.
Clean the motor protection filter by
tapping it.
If it is very dirty, the motor protection filter
should be rinsed.
The filter must then be left to dry for at
least 24 hours.
After cleaning, insert the motor protection
filter into the appliance as far as it will go
and close the dust bag compartment lid.
You can obtain a new motor protection filter
on request as a spare part from the after-
sales service. (see Spare parts, page 15 )
17
16
15
Figure
Hard-floor brush
For vacuuming hard floor coverings (tiles,
parquet flooring, etc.)
Push the telescopic tube into the connect-
ing piece of the hard-floor brush until it
engages.
Press on the unlatching sleeve and pull out
the telescopic tube to disconnect.
Figure
You can use the parking aid on the back of
the vacuum cleaner if you wish to stop
vacuuming for a short time.
Slide the plastic lug on the tool connector
into the groove at the back of the vacuum
cleaner.
When the work is done
Figure
Switch the vacuum cleaner off and unplug
the power cord from the mains.
Tug the power cord and let go. The cable
then rewinds automatically.
To reactivate or deactivate the cable brake,
quickly tug the power cord.
Figure
To store or transport the vacuum cleaner,
use the storage aid on the underside of the
vacuum cleaner. Stand the vacuum cleaner
up on its end. Slide the plastic lug on the
floor tool into the groove on the underside
of the unit.
Changing the dust bag and filters
Replacing the MEGAfilt ® SuperTEX dust bag
Figure
If the dust bag change indicator lights up
brightly and evenly when the floor tool is
lifted from the carpet and the highest suc-
tion power is selected, the dust bag must
be changed, even though it may not yet be
14
13
12
11
10*
13
en
Innenteil 275 552 B 25.09.2007 9:06 Uhr Seite 13