Bosch Home controller AA, Instruction Manual

Page: 10 / 19

18 19
5.2 Installing the controller
www
1)
After initialization, the cloud LED flashes when data is being exchanged via the tunnel connection.
Status LED state
Start All three LEDs are lit up red for a few seconds
Start-up
Power LED flashes white:
The device is starting up
Power LED is lit up white:
The device has started up
Network connection
Network LED flashes white:
Device is searching for a network connection
Network LED is lit up white:
The network connection has been established
Internet connection
Cloud LED flashes white:
Device is searching for an internet connection
1)
Cloud LED is lit up white:
The internet connection has been established
Insert the network cable into the
controller and into a free LAN port
on your WLAN router.
Now use the power cable to connect
the controller to the plug socket.
After the device starts, the LEDs show
the initialization status using flash
codes (see table).
When you connect the controller to the internet for the first time, it will
automatically search for software updates. If an update is required, it
will be downloaded automatically by the controller and installed. This
process may take up to 30 minutes. controller setup cannot begin until
this process is complete.