Bosch HGA223326Z, Instruction Manual

Page: 16 / 28

16
Setting the oven
Here you can find out how to set the oven.
This is how you adjust the lower gas burner in
the oven
When the lower gas burner is lit, you can bake on a baking
sheet with the oven door closed.
Example in the picture: Baking at 170 °C
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Open the main gas supply to the appliance. Connect the plug
to the socket. Open the oven door.
3.
Push in the switch for the lower gas burner and turn it to
170 °C.
4.
While holding the switch for the lower gas burner depressed,
press the ignition button 8 .
5.
The gas escaping from the oven's lower gas burner is ignited
using the ignition button. To activate the safety ignition, press
and hold the lower gas burner on the oven for 10 seconds.
The safety ignition is activated. If the gas flame goes out, the
gas supply is automatically interrupted by the safety ignition
system.
6.
Look through the inspection port to make sure that the flame
is lit. If it is not, repeat the process from step 3.
7.
Close the oven door slowly.
8.
Preheat the empty oven for approximately 15 minutes before
baking.
9.
When the dish has finished cooking, turn off the switch for the
lower gas burner.
You can change the temperature at any time.
:
Caution:!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
Setting the gas grill
1.
Open the top cover. The top cover must remain open for as
long as the cooker is in operation.
2.
Turn on the main gas supply to the appliance. Insert the plug
into the socket.
3.
Insert the protecting plate into the groove below the control
panel.
Insert the protecting plate with the longer edge at the front
and the curvature at the bottom.
Secure the protecting plate in the groove below the control
panel using the retainers.
Ensure that the protecting plate is engaged in the retainers. If
the protecting plate cannot be pulled out, it is engaged
correctly. You can now safely use the protecting plate. If it
can be removed, insert it into the groove at a slightly higher
angle and make sure that it engages in the retainers.
4.
Close the oven door so that it is as close as possible to the
protecting plate.
5.
Push in the function selector and turn it clockwise to the grill
setting ( .
6.
Keep the function selector pressed in and press the ignition
button 8 at the same time.
7.
The gas coming from the gas grill is ignited using the ignition
button. Keep the function selector pushed in for 10 seconds
so that the safety pilot starts up.
The flame failure device is activated. If the gas flame goes
out, the gas supply is automatically shut off by the flame
failure device.
8.
Check whether the flame is lit. If the flame goes out, repeat
the process from step 5.
9.
Once the food is cooked, switch off the function selector.
Once the oven has cooled down, remove the protecting
plate.
:
Caution!
The burner knob should not be actuated for longer than 15
seconds in the ignition position. If the burner does not ignite
within 15 seconds, wait at least one minute. Then repeat the
process to light the burner.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.