English 16 9000989331 Rev D
Removing the Warming Drawer
1.
Pull drawer to fully open position.
2.
Press down right drawer clip.
3.
Lift up left drawer clip.
4.
Firmly pull the drawer straight out. Retract housing
slides while drawer is removed.
Replacing the Warming Drawer
1.
Be sure housing slides are pushed inside housing.
2.
Align the drawer rails with the housing slides attached
to the drawer housing.
3.
Firmly push the drawer straight into the drawer housing
until the drawer clicks into place.
Note:
The drawer has
a “push-to-open” operation. Pressing the lower center
front of the drawer causes the drawer to self-open.
4.
Open and close drawer to test operation.
Note:
if the
drawer will not close, verify that the rails on the drawer
are properly aligned to housing slides and that the rail
release levers are properly positioned.
Testing Operation
Test the Oven
1.
Turn on power at the breaker.
2.
Test the oven mode.
Select the
BAKE
mode. See the Use and Care Manual
for detailed operation instructions.
3.
Verify that the oven light comes on and the oven begins
to preheat.
4.
Test the door lock.
Set the
SELF CLEAN
mode. Confirm that the door
locks when the lock icon appears in the display.
5.
If any of the tests do not result as explained above,
contact Bosch service for assistance. Otherwise,
continue with testing the rangetop burners.
If any of the tests do not result as explained above, contact
Bosch Service for assistance. Otherwise, the installation is
complete at this time.
9
CAUTION
To prevent burns, do not remove drawer while hot.
Be sure the drawer is empty before removing.
Parts
1
Housing
2
Drawer
3
Housing slide
4
Drawer rail
LOW
HIGH
_
MED
PROO
F
+
ON/O
FF
Summary of Contents for HEI80
Page 1: ...Installation Instructions Electric and Induction Ranges Slide In Ranges HEI80 HEIP0 HIIP0 ...
Page 39: ......
Page 59: ......
