-9-
REVERSING SWITCH LEVER
This tool is equipped with a rotating brush
reversing system. This results in longer tool life
while maximizing power in both forward and re -
verse directions. The reverse switch can be
oper ated from either the right or left side of the
tool.
FOR FORWARD ROTATION: slide switch to
arrow marked forward (Fig. 4).
FOR REVERSE RO TATION: slide the slide
switch to arrow marked re verse. NOTE: Tool
will not operate in middle position (Fig. 5).
REVERSING
SWITCH
LEVER
FIG. 4
FIG. 5
REVERSING
SWITCH
LEVER
DRILL/HAMMER DRILL SELECTION
SWITCH
The selector switch allows the tool to be set for
various drilling/hammer drilling applications.
Move the selector switch right or left
depending on the below applications (Fig. 1).
Do
not
operate
the
selection switch until the
tool comes to a complete stop.
Shifting
during rotation of the chuck can cause damage
to the tool.
Drill only action: For drilling in
woods, metals, plastics or other
non concrete materials.
Drill with hammer action: For
drilling in masonry, asphalt, tile or
other similar hard materials.
!
CAUTION
GEAR SELECTION DIAL
Gear selection: The proper gear selection is
directly related to the speed and torque
required for various jobs. The following should
be adhered to when selecting the proper gear:
Speed 1 = low speed with high
torque
Speed 2 = high speed with low
torque
Changing gears: Change gear position only
with the motor at a complete standstill. To
change gears rotate the gear selection dial. If
you have difficulties changing from one gear to
the other, turn the chuck by hand until the
gears engage (Fig. 1).
CHUCK KEY & STORAGE AREA
Your tool is equipped with a chuck key that is
conveniently located on the cord protector
where it is always handy and unlikely to get lost
or misplaced.
BM 2609932660 06-11:BM 2609932660 06-11 6/1/11 8:54 AM Page 9
