-13-
Assembly
Lock Nut and Backing Flange
Y o u r t o o l i s e q u i p p e d w i t h a t h r e a d e d
spindle for mounting ac ces sories. Always
use the supplied lock nut (and backing
f l a n g e ) t h a t h a s s a m e t h r e a d s i z e a s
spindle. Backing flange is keyed.
Disc Grinding Wheel
Assembly
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
Place BACKING FLANGE and GRINDING
WHEEL on the spindle.
Thread on the lock nut and tighten it using
the supplied wrench, while holding the
spindle lock (Fig. 5).
TO REMOVE: Reverse procedure.
WHEN USING SPIN-ON WHEELS
Follow steps 1 & 2, then thread wheel
directly onto spindle without using the
supplied flanges.
TO REMOVE: Reverse procedure.
All parts of a spin-on wheel must be within
lip of grinding guard (Fig. 6). If spin-on
wheel is past lip of guard, do not use that
wheel as it does not fit on this grinder.
Do not use accessories
that run eccentrically.
The tool will vibrate excessively and may
cause loss of control and the accessory may
burst.
Type 27
Spin-on
Grinding
Wheel
Spindle
Type 27
Wheel
Guard
Backing
Flange
Lock
Nut
Fig. 5
Type 27
Grinding
Wheel
Spindle
Backing
Flange
Lock Nut
Fig. 6
Lip of Guard
Spin-On Wheel
Type 27
Grinding Wheel
