60
| English
1 609 929 U05 | (9.6.09)
Bosch Power Tools
– Screw the wooden pieces (max. height
95 mm) onto the fence rails. The screw
heads must be flush with the wood surface
or countersunk.
Extending the Saw Table
(see figure
C)
Long workpieces must be underlaid or support-
ed at their free end.
– Loosen both Allen screws
42
with the Allen
key
5
provided.
– Pull out the saw table extension
31
to the
stop and tighten the Allen screws again.
Mounting the Extension Bars
(see figure
D)
To extend the saw table additionally, extension
bars can be mounted both to the left or right of
the power tool.
– Insert the extension bars
43
on both sides of
the power tool to the stop in the drill holes
44
intended for this purpose.
– Firmly tighten the screws of the extension
bar.
Clamping the Workpiece
(see figure
E)
To ensure optimum working safety, the work-
piece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
f
While clamping the workpiece, do not reach
under the clamping lever of the quick-
clamping fixture with your fingers.
– Press the workpiece firmly against the
fence
32
.
– Insert the quick-action clamp
23
into one of
the holes
30
intended for it.
– Adapt the quick-action clamp to the work-
piece by turning the threaded rod
45
.
– Push on the clamping lever
46
in order to
clamp the workpiece.
Adjusting the Cutting Angle
f
Before any work on the machine itself, pull
the mains plug.
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use (see “Checking
and Adjusting the Basic Adjustment”, page 65).
f
Always tighten the locking knob 27 firmly
before sawing.
Otherwise the saw blade can
become wedged in the workpiece.
– Bring the power tool into the chop and mitre
saw working position. (see “Working Posi-
tion”, page 59)
Adjusting Horizontal Standard Mitre Angles
(see figure
F)
For quick and precise adjustment of commonly
used mitre angles, detents
29
have been provid-
ed for on the saw table:
– Loosen the locking knob
27
in case it is tight-
ened.
– Pull lever
28
and rotate the saw table
24
left
or right to the requested detent.
– Release the lever again. The lever must be
felt to engage in the detent.
Adjusting Any Horizontal Mitre Angle
(see figure
G)
The horizontal mitre angle can be set in the
range from 48° (left side) to 48° (right side).
– Loosen the locking knob
27
in case it is tight-
ened.
– Pull lever
28
and at the same time push the
locking bracket
47
until it engages in the
groove intended for this. The saw table can
be moved freely now.
– Turn the saw table
24
left or right by the lock-
ing knob and adjust the requested mitre an-
gle with help of the fine scale
48
. (also see
“Adjusting with Help of the Fine Scale”,
page 61)
– Tighten the locking knob
27
again.
Left
Right
0°
15°; 22.5°;
31.6°; 45°
15°; 22.5°;
31.6°; 45°
OBJ_BUCH-302-005.book Page 60 Tuesday, June 9, 2009 2:19 PM