English |
19
Bosch Power Tools
2 609 932 532 | (25.7.07)
Selecting a Saw Blade
An overview of recommended saw blades can be
found at the end of these instructions. Use only
T-shank saw blades. The saw blade should not be
longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
Before inserting the saw blade
9
, set the adjust-
ing lever for orbital action
6
to setting
III
.
–
Press the orange pushbutton in the rotatable
top handle
1
down until it can be felt to en-
gage.
–
Turn the rotating handle
1
approx. three turns
in the direction of the arrow.
–
Insert the saw blade
9
lateral to the cutting di-
rection into the stroke rod
11
.
–
Turn the saw blade
9
so that the toothing fac-
es toward the cutting direction. Pull the saw
blade
9
a little downward until it engages.
–
Turn the rotating handle
1
in the direction of
the arrow until a click can be heard.
–
Push up the orange pushbutton at the rotata-
ble top handle
1
again to the starting position.
f
Check the tight seating of the saw blade.
A
loose saw blade can fall out and lead to inju-
ries.
Splinter Guard (see figure B)
f
Before any work on the machine itself, pull
the mains plug.
The splinter guard
12
(accessory) can prevent
fraying of the surface while sawing wood. The
splinter guard can only be used for certain saw
blade types and only for cutting angles of 0°.
When sawing with the splinter guard, the base
plate
7
must not be moved back for cuts that are
close to the edge.
Press the splinter guard
12
from the bottom into
the base plate
7
.
Operation
Operating Modes
f
Before any work on the machine itself, pull
the mains plug.
Orbital Action Settings
The four orbital action settings allow for optimal
adaptation of cutting speed, cutting capacity and
cutting pattern to the material being sawed.
The orbital action can be adjusted with the ad-
justing lever
6
, even during operation.
The optimal orbital action setting for the respec-
tive application can be determined through prac-
tical testing. The following recommendations ap-
ply:
–
Select a lower orbital action setting (or switch
it off) for a finer and cleaner cutting edge.
–
For thin materials such as sheet metal, switch
the orbital action off.
–
For hard materials such as steel, work with
low orbital action.
–
For soft materials and when sawing in the di-
rection of the grain, work with maximum or-
bital action.
Adjusting the Cutting Angle (see figure C)
The base plate
7
can be swivelled by 45° to the
left or right for mitre cuts.
–
Loosen the screw
14
and lightly slide the base
plate
7
in the direction of the saw blade
9
.
–
For adjustment of precise mitre angles, the
base plate has adjustment notches on the left
and right at 0° and 45°. Swivel the base plate
7
to the desired position according to the
scale
13
. Other mitre angles can be adjusted
using a protractor.
–
Afterwards, push the base plate
7
to the stop
toward the mains cable.
–
Tighten the screw
14
again.
The splinter guard
12
can not be inserted for mi-
tre cuts.
Setting
0
No orbital action
Setting
I
Small orbital action
Setting
II
Medium orbital action
Setting
III
Large orbital action
OBJ_BUCH-441-001.book Page 19 Wednesday, July 25, 2007 7:37 AM
