English |
5
Bosch Power Tools
2 609 140 772 | (12.7.10)
f
Switch off the power tool immediately
when the tool insert jams. Be prepared for
high reaction torque that can cause kick-
back.
The tool insert jams when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
f
Hold the machine with a firm grip.
High re-
action torque can briefly occur while driving
in and loosening screws.
f
Secure the workpiece.
A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
f
Keep your workplace clean.
Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
f
Do not open the battery.
Danger of short-
circuiting.
Protect the battery against heat, e. g.,
against continuous intense sunlight,
fire, water, and moisture.
Danger of
explosion.
f
In case of damage and improper use of the
battery, vapours may be emitted. Provide
for fresh air and seek medical help in case
of complaints.
The vapours can irritate the
respiratory system.
f
Use the battery only in conjunction with
your Bosch power tool.
This measure alone
protects the battery against dangerous over-
load.
f
Use only original Bosch batteries with the
voltage listed on the nameplate of your pow-
er tool.
When using other batteries, e. g. imi-
tations, reconditioned batteries or other
brands, there is danger of injury as well as
property damage through exploding batteries.
Additional Safety and Working
Instructions
f
Dusts from materials such as lead-contain-
ing coatings, some wood types, minerals
and metal can be harmful to one’s health
and cause allergic reactions, lead to respi-
ratory infections and/or cancer.
Materials
containing asbestos may only be worked by
specialists.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
f
Before any work on the machine (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the centre posi-
tion.
Unintentional actuation of the On/Off
switch can lead to injuries.
f
The battery is supplied partially charged. To
ensure full battery capacity, completely
charge the battery in the battery charger
before using for the first time.
f
The battery is equipped with a NTC temper-
ature control which allows charging only
within a temperature range of between
0 °C and 45 °C. A long battery service life
is achieved in this manner.
f
Read the operating instructions of the bat-
tery charger.
f
Apply the power tool to the screw only
when it is switched off.
Rotating tool inserts
can slip off.
f
Adjust the gear switch only when the ma-
chine is at a complete stop.
f
Always push the gear selector and turn the
operating mode selector switch through to
the stop.
Otherwise, the machine can be-
come damaged.
f
In case of excessive loading, e. g., pro-
longed blocking of the application tool, the
electronics switch off the power tool. After
switching on again, the power tool can be
used again as intended for. In case of con-
tinued overload, the power tool will switch
off again in order to prevent damage to the
motor.
OBJ_BUCH-1277-001.book Page 5 Monday, July 12, 2010 10:36 AM
