Troubleshooting
Greentherm T9900 SE/i – 6 720 813 635 (2019/03)
62
Access to
CA Combustion Adjust
menu is only possible after
accessing to
AU Technical Settings
menu (
After enter
AU Technical Settings
menu,
▶ Touch symbols
or
to select
CA
menu.
Display shows
CA Combustion Adjust
.
▶ Touch the symbol
to enter
CA
menu.
•
UC - Auto Adjust
•
MA - Manual Adjust
•
...
Fig. 55
CA Combustion Adjust
8.12.1 Automatic Gas and Air adjustment
The
UC Auto Adjust
is the automatic Gas and Air adjustment
process. This process takes approximately 15 minutes, and
does not requires any intervention besides insuring that
enough water flow is provided to the appliance.
To perform UC Auto Adjust of Gas/Air flow;
After enter
CA Combustion Settings
menu,
▶ Touch symbols
or
to select
UC
menu.
▶ Touch the symbol
to enter
UC
menu.
Automatic adjustment has initiated.
Fig. 56
Auto Adjustment
▶ Open hot water taps when the display shows
Open Taps
.
This message will appear approximately 5 minutes after
initiate the automatic adjustment.
The appliance will display
Open Taps
whenever more flow
is required to continue the automatic adjustment process
(1 tub and 2 sinks are usually sufficient).
Fig. 57
Auto Adjust - Open Taps
▶ Wait until a green check mark is displayed indicating the
successful conclusion of the automatic adjustment.
▶ Touch the symbol
to exit
UC
menu.
Fig. 58
Auto Adjust complete
Gas and Air auto adjustment is complete
.
In case of failure in the auto calibration process verify if:
▶ Gas type and pressure are correct (
▶ Vent length is according to specification (
▶ Wind conditions are stable (e.g. wind gusts may be a cause
of failure).
▶ Hot water flow is sufficient and stable (e.g. water from a
well is a potential source of water instability).
In case of positive results for all these actions:
▶ Perform manual adjustment according to chapter 8.12.2
or contact Bosch support line for further assistance.
