English |
33
Bosch Power Tools
1 609 929 R32 | (6.3.08)
To ensure that the distance from router bit cen-
tre and guide bushing edge is uniform, the guide
bushing and the guide plate can be adjusted to
each other, if required.
– When using the plunge base
2
: Push the re-
lease lever for the plunge base
21
downward
and lower the multifunction router to the
stop. Let go of the release lever
21
again in
order to lock the plunging depth.
– Loosen the fastening screws
55
approx.
2 turns so that the guide plate
14
is freely
movable.
– Insert the centring pin
56
into the tool holder
as shown in the figure. Hand-tighten the
tightening nut so that the centring pin can
still be moved freely.
– Align the centring pin
56
and the guide bush-
ing
54
to each other by slightly moving the
guide plate
14
.
– Tighten the fastening screws
55
again.
– Remove the centring pin
56
from the tool
holder.
– When using the plunge base
2
: Push the re-
lease lever for the plunge base
21
and raise
the multifunction router back to the upper-
most position.
For routing with the guide bushing
54
proceed
as follows:
–
Note:
Take into consideration that for rout-
ing work with the non-plunge base
3
, the
router bit
18
always protrudes out of the
base plate
12
. Do not damage the template
or the workpiece.
– Guide the switched on power tool with the
guide bushing toward the template.
– When using the plunge base
2
: Push the re-
lease lever for the plunge base
21
downward
and slowly lower the multifunction router un-
til the set depth-of-cut is reached. Let go of
the release lever
21
again in order to lock the
plunging depth.
– Guide the switched on power tool with the
protruding guide bushing alongside the tem-
plate applying lateral pressure.
Operation with Router Table (see figure S)
The non-plunge base
3
can be used with a suita-
ble router table. To install the router, remove
the guide plate
14
and fasten the non-plunge
base
3
to the router table with the fastening
screws
58
.
f
For mounting of the non-plunge base,
please observe the operating instructions
of your router table.
If necessary, matching
holes must be drilled into the router table in
order to mount the non-plunge base.
For fine adjustment of the depth-of-cut, it is
best to use the extension
59
or the specialty Al-
len key
57
.
Maintenance and Service
Maintenance and Cleaning
f
Before any work on the machine itself, pull
the mains plug.
f
For safe and proper working, always keep
the machine and ventilation slots clean.
f
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The pro-
tective insulation of the machine can be de-
graded. The use of a stationary extraction
system is recommended in such cases as
well as frequently blowing out the ventila-
tion slots and installing a residual current
device (RCD).
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
OBJ_BUCH-100-003.book Page 33 Thursday, March 6, 2008 10:50 AM