Microfilter Dust Canister
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
c a n i s t e r s h o u l d b e e m p t i e d f r e q u e n t l y
during operation.
Y o u r t o o l i s e q u i p p e d
w i t h a d u s t c a n i s t e r ;
empty it frequently after completion of
sanding and before storing the sander.
Be
extremely careful of dust disposal, materials
in fine particle form may be explosive. Do
not throw sanding dust on an open fire.
Combustion from mixture of varnishes,
lacquers, polyurethane, oil or water with
dust particles can occur if there is a static
discharge, spark introduced in the box, or
excessive heat.
Dust Collection
-10-
Backing Pad Damper
Your tool is equipped with an integrated
backing pad damper ring. This damper
reduces the no-load speed, which helps
p r e v e n t s w i r l m a r k s o n t h e w o r k p i e c e
surface and provides uniform finishing.
NOTE:
If you notice steadily increasing no-
load speed, this indicates that the damper
ring is worn and needs to be replaced.
To replace damper ring, remove backing
p a d a s d e s c r i b e d i n “ B a c k i n g P a d
Installation” and remove worn damper ring
by pulling firmly out of locating groove.
Align notch on damper ring with locating
t a b o n s h r o u d a n d d e p r e s s r i n g w i t h
t h u m b s u n t i l s h r o u d s e a t s i n t o g r o o v e
completely around ring (Fig. 4).
R e - a t t a c h b a c k i n g p a d a s d e s c r i b e d i n
“Backing Pad Installation”.
IMPORTANT:
Ring should not have bends or
ripples when correctly seated.
DAMPER
RING
SHROUD
BACKING
PAD
LOCATING
TAB
FIG. 4
NOTCH
Assembly
DUST
CANISTER
FIG. 5
DUST
PORT
