English |
37
Bosch Power Tools
1 609 929 X03 | (29/7/10)
– Keep the spindle lock
40
pressed and un-
screw hexagon bolt
41
in clockwise direction
(left-hand thread!)
.
– Remove the washer
42
and the clamping
flange
43
.
– Remove the saw blade
7
.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Place the new saw blade onto the interior
clamping flange
44
.
f
Take care during the mounting that the cut-
ting direction of the teeth (direction of the
arrow on the saw blade) agrees with the di-
rection of the arrow on the retracting blade
guard!
– Mount the clamping flange
43
, the washer
42
and the hexagon bolt
41
.
Press spindle lock
40
until it engages and
tighten hexagon bolt
41
with the provided
ring spanner
35
. (Tightening torque approx.
20 Nm)
– Push the locking lever
4
and guide the re-
tracting blade guard
8
down again.
– Retighten the screws
39
and
38
.
Operation
f
Before any work on the machine itself, pull
the mains plug.
Transport Safety (see figure E)
The transport safety-lock
33
enables easier han-
dling of the machine when transporting to vari-
ous working locations.
Releasing the Machine (Working Position)
– Push the tool arm by the handle
6
down a lit-
tle in order to relieve the transport safety-
lock
33
.
– Pull the transport safety-lock
33
all the way
outward and turn it by 90°. Allow the trans-
port safety-lock to engage in this position.
– Guide the tool arm slowly upward.
Securing the Machine (Transport Position)
– Loosen the locking screw
26
if tightened.
Pull the tool arm completely to the front and
tighten the locking screw again.
– Screw the depth stop
51
completely to the
top. (see “Adjusting the Depth Stop”,
page 40)
– To lock the saw table
17
, tighten the locking
knob
13
.
– Pull the transport safety-lock
33
all the way
outward and turn it by 90°. Allow the trans-
port safety-lock to engage in this position.
– Push the locking lever
4
and at the same time
lower the tool arm via handle
6
until the
transport safety-lock engages in the end po-
sition.
The tool arm is now securely locked for trans-
port.
Preparing for Operation
Extending the Saw Table (see figure F)
Long workpieces must be underlaid or support-
ed at their free end.
– Loosen both Allen screws
19
with the Allen
key
30
provided.
– Pull out the saw table extension
21
to the
stop and tighten the Allen screws again.
Mounting the Extension Bars (see figure G)
To extend the saw table additionally, extension
bars can be mounted both to the left or right of
the power tool.
– Mount one length stop
52
each onto an ex-
tension bar
45
.
– Insert the extension bars
45
on both sides of
the power tool to the stop in the drill holes
20
intended for this purpose.
– Tighten the screws for securing the exten-
sion bars.
OBJ_BUCH-1126-002.book Page 37 Thursday, July 29, 2010 12:07 PM
