Disconnect battery
p a c k f r o m t o o l o r
place the switch in the locked or off
position before making any assembly,
adjustments or changing accessories.
Such preventive safety measures reduce
the risk of starting the tool accidentally.
▶ Inserting and Releasing
Battery Pack
S e t F o r w a r d / R e v e r s i n g l e v e r t o t h e
center (locked position). Slide charged
battery pack into the housing until the
battery pack locks into position (Fig. 2).
Your tool is equipped with a secondary
locking latch to prevent the battery pack
f r o m c o m p l e t e l y f a l l i n g o u t o f t h e
handle, should it become loose due to
vibration.
To remove the battery pack, press the
battery pack release button and slide
the battery pack completely out of tool
housing (Fig. 2).
▶ Installing SDS-plus®
Accessories
C l e a n t h e i n s e r t s h a n k e n d o f t h e
accessory to remove any debris, then
l i g h t l y g r e a s e w i t h a l i g h t o i l o r
lubricant.
Insert accessory into the chuck through
t h e d u s t s h i e l d , w h i l e t w i s t i n g a n d
p u s h i n g
i n w a r d
u n t i l
i t
l o c k s
automatically into place. Pull outward
on the accessory to be certain it is
locked into the chuck (Fig. 3).
NOTE: The high efficiency available
from the rotary hammers can only be
o b t a i n e d i f s h a r p a n d u n d a m a g e d
accessories are used. The "cost" to
m a i n t a i n
s h a r p
a n d
u n d a m a g e d
accessories is more than offset by the
"time saved" in operating the tool with
sharp accessories.
▶ Removing SDS-plus®
Accessories
Accessories may be
hot after use.
Avoid
c o n t a c t w i t h s k i n a n d u s e p r o p e r
protective gloves or cloth to remove.
To remove an accessory, pull locking
sleeve backward and pull bit forward.
All accessories should be wiped clean
after removing (Fig. 4).
Disconnect battery
p a c k f r o m t o o l o r
place the switch in the locked or off
position before making any assembly,
adjustments or changing accessories.
Such preventive safety measures reduce
the risk of starting the tool accidentally.
▶ Installing and Removing
3-Jaw Chuck
(Not included, available as accessory)
-10-
DUST
SHIELD
Assembly
FIG. 4
FIG. 3
LOCkING
SLEEVE
BATTERy PACk
RELEASE
BUTTON
BATTERy
PACk
FIG. 2
2610051859_GBH18V-26D 11/19/18 9:33 AM Page 10
