12
Starting the Dishwasher
When the correct cycle and options are shown in
the display window and you have added detergent
and rinse aid as explained in the
Adding
Detergent and Rinse Aid
section of this manual,
press the START button and close the door.
After pressing the START button, the display will
show the following information:
·
“Close the door”.
·
Estimated completion time (this estimated
time automatically adjusts throughout the
cycle based on incoming water temperature
and selected options).
·
Current cycle name.
·
“Return” (allows you to choose another
cycle).
Close the dishwasher door. The dishwasher will
begin and run until the cycle is complete.
When the cycle ends, the dishwasher will emit an
end of cycle tone (five times). Open the
dishwasher door. The display will briefly show
“Clean”. After 5 seconds the dishwasher will
automatically turn off.
NOTE:
To accelerate and enhance drying, open
the dishwasher door, pull the top rack a few
inches out of the dishwasher, and prop the
dishwasher door against the top rack.
Operating the Dishwasher
(continued)
Standard Programs
The wash cycles available in this hidden menu
are special wash cycles that may be used to
solve special needs in the field.
NOTE:
In the Options Step Down Menu you can
return to the main menu at any time by pressing
the START button.
1. Open the dishwasher door far enough to
expose the control panel.
2. Press the ON/OFF button.
3. Press the MENU/OK button eight times to
display the screen “STANDARD
PROGRAMS”.
You must press the button
nine times if you are out of rinse aid.
4. After the “STANDARD PROGRAMS” screen
is displayed, press the + button one time to
display available wash cycles. Those cycles
are:
·
Regular – normal wash cycle.
·
Enviro Care – reduces water and energy
consumption.
·
Glass Care – reduces temperatures to
reduce glass damage.
·
Extreme Wash - for extremely hard to
remove food soils.
3. Press the MENU/OK button seven times to
display the current language setting.
You
must press the button eight times if you are
out of rinse aid.
4. The available language choices are:
·
AE = American English
·
CF = Canadian French
·
MS = Mexican Spanish
5. Press the + or – buttons until the desired
language flashes.
6. After changing the language selection, you
must press the MENU/OK button to save the
setting. The display will show “Value Stored”
and return to the main menu. If you did not
change the language, press the START
button to return to the main menu.
7. Select the desired wash cycle by pressing
the – or + buttons.
8. Press START and close the dishwasher
door to begin the cycle.
5. Press the + or – buttons until the desired
wash cycle is displayed.
6. When the desired setting is displayed, press
the START button and close the door to
begin the cycle.
Interrupting a cycle
Open the dishwasher door far enough to expose
the control panel. The display will show:
• “Close the door”.
• the remaining cycle time.
• the selected cycle.
• the cycle phase.
• “Cancel Program”.
WARNING
You could be seriously scalded if you open
the dishwasher door quickly during a wash
or rinse cycle. Do not fully open the
dishwasher door for at least 10 seconds or
until water noises stop.
