10. INSTALLATION
FACTORY SETTINGS
parameter [4.5] > Automatic calibration of wheel circumference: If the bike is stopped, the
•
message 55.6 will appear on the display for a few seconds, at the end of calibration 50.1
appears. If the bike is moving or the magnet on the spokes is positioned above the sensor,
calibration is NOT STARTED and 99.9 appears on the display;
parameter [5.5] > Km Reset ODO and TRIP calculated in unlocker mode;
•
parameter [6.5] > software version
•
4.
Make the choice and wait for about 5-10 seconds to enter the parameter to be modified.
5.
Change the value with the [+ -] keys as desired: then wait a few seconds until the value is
positioned at 0.0.
For Intuvia displays
1.
Modify the default parameters by specifying you will be using an Intuvia display ( see point 3,
parameter [1]
2.
At first use you’ll have to reset Trip.
3.
For technical reasons, only on Intuvia display, the total distance will start from ‘0’ and will
increase until the bike is switched off . When you turn the bike on again, the value will restart
from ‘0’. In order to visualize the total kms travelled, it will be necessary to press the INFO button
and position on the ‘TOTAL KM’, then follow Point 3, parameter [0]
4.
The partial Km will continue to increase until they are not put back to zero with the RESET
button.
Attention:
the visualization of the total Km travelled will be possible only after having covered
at least 100 km
For Nyon display
it is necessary to change the factory parameters specifying that the Nyon display is used. See
point 3, parameter 1.5
Warning: the Nyon display will show the correct speed and the kilometers done with the unlock
activated halved.
YOUTUBE VIDEO:
https://youtu.be/qr_QfI5uDdc