7
CEILING
Set-up Lead.
T-Connector.
Connect video out lead here.
(make power connections first.)
Note clamp in
extended position.
Power Leads.
Rotate T-Connector
for clear access.
Mounting Clamps (3).
Fold in to install unit.
Clamps swing out
to secure unit.
Lanyard
Ceiling Surface.
Cut Ø 146mm
(5-3/4 inch) hole.
Dome & Trim Ring Assembly.
Attaches to base with twist-lock
connection. Align colored marks
on trim ring and base unit, then
twist clockwise to secure.
Base Unit
with Camera.
Inner Liner.
Snaps into base unit.
Screws to tighten
Retaining Clamps.
Retaining Clamps.
Fold in for installation; fold out
and screw down to secure unit.
Figure 1 Ceiling Mount Power & Video Connections
2. Install the base assembly box into the precut hole until the base’s flange hits the ceiling. Tighten the three screws that
serve to lower the mounting clamps to grab on to the ceiling. Be sure the clamps are secure against the ceiling (see
Figure 2
).
3. Adjust the camera module for proper viewing angle. See
Section 4.3
for more information on camera adjustments.
4. Once the camera is positioned properly, install the black inner liner and align the viewing slot with the camera and
lens (see
Figure 2
).
5. When the inner liner is properly located, install the dome and trim ring by lining up the colored dots and rotating
clockwise until it is locked in place.
Figure 2 In-ceiling Installation
Summary of Contents for DMExPCHxx
Page 1: ...Instruction Manual EN Integrated Fixed Dome DME Series ...
Page 14: ...13 ...
Page 15: ...14 ...
