Bosch DIP-5042EZ-0HD, Installation Manual

Page: 6 / 46

6 en | Safety DIVAR IP 5000
2016.03 | V1 | DOC
Bosch Sicherheitssysteme GmbH
– For added protection during a lightning storm, or when
leaving this unit unattended and unused for long periods,
unplug the unit from the wall outlet and disconnect the
cable system. This will prevent damage to the unit from
lightning and power line surges.
– Power supply cords should be routed so that they are not
likely to be walked on or pinched by items placed upon or
against them, playing particular attention to cords and
plugs, convenience receptacles, and the point where they
exit from the appliance.
– Do not open or remove the cover to service this unit
yourself. Opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all servicing to
Bosch Service Center.
– Observe the relevant electrical engineering regulations.
– Use proper CMOS/MOS-FET handling precautions to avoid
electrostatic discharge when adding or changing hard
disks.
– Install the unit only in a dry, weather-protected location.
– When installing in a switch cabinet, ensure that the unit and
the power supply units have sufficient grounding.
– Connect the unit to an earthed mains socket.
– For protection of the device, the branch circuit protection
must be secured with a maximum fuse rating of 16 A. This
must be in accordance with
NEC800 (CEC Section 60) .
– All the input/output ports are Safety Extra Low Voltage
(SELV) circuits. SELV circuits should only be connected to
other SELV circuits.
– Disconnect the power before moving the unit. Move the
unit with care. Excessive force or shock may damage the
unit and the hard disk drives.
– If safe operation of the unit cannot be ensured, remove it
from service and secure it to prevent unauthorized
operation. In such cases, have the unit checked by Bosch
Security Systems.