DICENTIS
Meeting application | en
71
Bosch Security Systems B.V.
Configuration manual
2021.06 | V3.7 |
–
Camera name
: this is the default name of a connected camera.
In the
Camera name
column on the right side of the screen, you can change it to a logical
name, e.g. right-side or front. This makes it easier to identify the camera when assigning it
to a seat in the
Seats and devices
–
Type:
This is the type of camera connected, e.g. PTZ (Pan Tilt Zoom).
Configuring additional video streams
The DICENTIS system can discover Onvif Profile‑S compatible cameras, allowing the active
speaker to be displayed on the multimedia device.
However, other video input solutions and even HD-cameras that convert their video through
encoders can be configured, so that the DICENTIS system can detect them as if they are
supported cameras. The provided video streams should comply with the standards used
within the system (e.g. Real-Time Streaming Protocol, RTSP).
The H.264 (data type/codec) stream is packed in RTP stream according to:
https://www.rfc-editor.org/info/rfc3984
It can be configured as:
–
direct RTP stream (unicast and multicast).
–
RTP stream served by an RTSP server (unicast and multicast).
The settings of the H.264 stream are:
- Set the main frequency of the HD conference dome from 50Hz to 60Hz to reduce the latency
(Settings\Advanced mode\Camera\Installer Menu).
–
720p50 or 720p60 if you have multimedia devices. 1080p50 or 1080p60 if you only have
DCNM-IDESKVID devices.
–
Target bit‑rate 2Mbit/s.
–
Maximum bit-rate 2.5Mbit/s.
–
GOP length 15 (also known as I-Frame distance).
–
No B‑frames, I and P frames only.
5.4.8
Seats and devices
The main purpose of this screen is to assign seats to, and un-assign seats from, devices.
If the
Automatic seat assignment
checkbox under the
Rooms
tab is selected, a new device
connected to the system is automatically assigned to a seat and has the seat license assigned,
when available.
The
Automatic seat assignment
checkbox under the
Rooms
tab should not be selected if you
want to manually assign and un-assign seats. Use the
Assign Device to Seat
button and
Unassign Devices from Seat
button to manually assign and un-assign devices. These buttons
and their associated options are described in the following sections:
Seat Assignment pane
–
Configure mode (select on device):
Used for locating devices. When this checkbox is
selected, a
Select device
button is displayed on all devices. Pressing this button or the
microphone button:
–
switches on the microphone LED.
–
displays a crosshair in the
Select
column next to the seat and device name. When
the device is selected, the crosshair is clear against a blue background. When the
device is not selected, the crosshair becomes blue in a clear background. This
feature can be particularly useful when you want to locate seat positions in a large
conference hall.
