en
Installation instructions
26
▶
If this is not possible, an all-pole
isolating switch must be integrated
into the permanent electrical in-
stallation according to the condi-
tions of overvoltage category III
and according to the installation
regulations.
▶
The permanent electrical installa-
tion must only be wired by a pro-
fessional electrician. We recom-
mend installing a residual-current
circuit breaker (RCCB) in the appli-
ance's power supply circuit.
Sharp-edged components inside the
appliance may damage the connect-
ing cable.
▶
Do not kink or trap the connecting
cable.
¡
The connection data can be found
on the rating plate. →
¡
The connecting cable is ap-
prox. 1.30 m long.
¡
This appliance complies with the
EC interference suppression regu-
lations.
¡
The appliance corresponds to pro-
tection class 1. You should there-
fore only use the appliance with a
protective earth connection.
¡
Do not connect the appliance to
the power supply during installa-
tion.
¡
Ensure that the protection against
contact is guaranteed during in-
stallation.
12.10 Installation
Checking the wall
1.
Check whether the wall is vertical
and has sufficient load-bearing ca-
pacity.
2.
Drill the hole depth in accordance
with the length of the screws.
The wall plugs must have a secure
grip.
3.
The screws and wall plugs en-
closed are only suitable for use
with solid brickwork.
Suitable fasteners must be used
for other structures, e.g. plaster-
board, aerated concrete, Poroton
blocks, masonry bricks.
4.
The maximum weight of the appli-
ance is 16 kg.
Preparing the wall
1.
Ensure that there are no electrical
wires, gas pipes or water pipes in
the area where holes are to be
drilled.
2.
Mark a vertical centre line on the
wall from the ceiling to the lower
edge of the appliance.
