Bosch D-tect200C, Operating/Safety Instructions Manual

Page: 16 / 56

-16-
homogeneous materials. Plastic and metal
objects as well as electrical and other cables are
displayed. Cavities in masonry or empty plastic
pipes with a diameter of less than 0.8 in (2 cm)
may not be displayed.
Wall Type <Concrete>
The <Concrete> wall type is suitable for
applications in dry concrete. It displays plastic
and metal objects as well as electrical and other
cables. Empty plastic pipes with a diameter of
less than 0.8 in (2 cm) may not be displayed.
When selecting the wall type, you can
additionally set the maximum measuring depth
between 3.15 (8 cm) and 7.8 in (20 cm).
Wall Type <Drywall>
The <Drywall> wall type is suitable for detecting
timber joists and metal supports, as well as
electrical and other cables in drywalls (wood,
plasterboard, etc.). Filled plastic pipes and
wooden beams appear identical on the display.
Empty plastic pipes are not recognized.
Wall Type <Panel Heating>
The <Panel Heating> wall type is especially
suitable for detecting metal, metal-composite
and water-filled plastic pipes and electrical
cables. Empty plastic pipes are not displayed.
Wall Type <Vertical Coring Brick>
The <Vertical Coring Brick> wall type is
especially suitable for applications in vertically
perforated bricks. Vertically perforated bricks
are bricks with many small, mostly vertical,
cavities. It displays metal objects, electrical and
other cables, as well as water-filled plastic pipes.
Cavities or empty plastic pipes may not be
displayed.
Wall Type <Horizontal Coring Brick>
The <Horizontal Coring Brick> wall type is
especially suitable for applications in
horizontally perforated bricks. Horizontally
perforated bricks are bricks with a few, mostly
horizontal, cavities. It displays flat lying metal
objects, electrical and other cables, as well as
water-filled plastic pipes up to a maximum
measuring depth of 2 in (5 cm). Cavities or
empty plastic pipes may not be displayed.
Wall Type <Early Age Concrete>
The <Early Age Concrete> wall type is especially
suitable for applications in concrete which has
not yet fully cured and dried. Metal objects,
plastic and metal pipes as well as electrical
cables are displayed. A distinction between live
and voltage-free conductors is not possible. The
maximum measuring depth is 6 cm.
Please observe that concrete requires several
months to cure and dry completely.
Change the view
To change the view, repeatedly press the top
(17) or bottom select button (12) until the
required view is displayed. Press the red start
button
(16) to accept the selection.
<Spot View>
In the <Spot View>, a first measuring result is
already displayed without moving the detection
tool
over the substrate. It is therefore
particularly suitable for measurements in
corners or narrow places. The maximum
measuring depth is 6 cm. Objects found are
displayed with material properties, if available,
but without depth information.
Whenever possible, you should also move the
detection tool over the substrate in the
<Spot
View> to ensure the best possible
measurements. Locating plastic pipes and
timber joints is particularly limited without
moving the detection tool.
Measuring indicator:
If no object is found, only the outer circle will
appear on the display and it will light up green.
If there is an object nearby, the outer circle will
light up red. The closer the detection tool is to
an object, the more the deflection in the
measuring indicator (number of circles) will
increase. The deflection decreases when the
detection tool moves away from the object.
Orientation arrows are displayed if the signal
strength is sufficient. To specifically locate the
object's center, move the detection tool in the
direction of the orientation arrows.
Operating Instructions
Dtect200C_2610067510_01-22.qxp_D-tect200 1/18/22 1:43 PM Page 16