Page
4
P/N: CM710BIRG Rev 1.3
E&OE
Copyright © 2012
Output Defaults - Solution 144 and Solution E Panels
The table below list the default values for all output parameters in the Solution 144 and Solution E. Outputs 1 to 4
are High current digital outputs and Output 5 is the on board relay output. Outputs 9 to 72 are only available if the
optional Output Relay Expander Modules (CM710B) or Universal Expander Modules (CM705B) are fitted. Options
marked N/A = Not Applicable.
Programming Option
Output 1
Output 2
Output 3
Output 4
Output 5
Output 9 - 40
Output Name
External
Siren
Strobe
Light
Smoke Sensor
PWR
Internal
Siren
On Board
Relay
Output x Name
Event Type
36
(External
Siren)
48
(Strobe)
49
(Smoke Sensor
GND)
37
(Internal
Siren)
54
(Keyfob
Function 2)
00
(Not Used)
Event Assignment
0
0
0
0
0
0
Output Polarity
14
Speaker
Output
6
1 Shot Low +
Reset
11
Low 1 Shot
Open
6
1 Shot Low +
Reset
4
Open 1 Shot
Low
0
Open
To Low
Time Parameter
N° Of Hours
000
008
000
000
000
000
N° Of Minutes
005
000
000
005
000
000
N° Of Seconds
000
000
010
000
002
000
N° Of 1/10 Seconds
000
000
000
000
000
000
Output Options
Off On Low Battery
Y
Y
N
Y
N
N
Guest Control
N
N
N
N
N
N
Reserved
N
N
N
N
N
N
Monitor Overload
Y
Y
Y
Y
N
N
Monitor Device Fail
Y
Y
N
Y
N
N
Alarm On Device Fail
N
N
N
N
N
N
Block If All On
N
N
N
N
N
N
Show Status On Keypad
N
N
N
N
N
N
Show Status On Keypad
N
N
N
N
N
N
Table 4: Solution 144 and Solution E Output Defaults
Zone Allocation When Using the CM705B Universal Expander
The Solution 144 and Solution E panels also support the CM705B Universal Expander Modules. The CM705B is like
having 1 x CM704B zone expander, 1 x CM710B output expander and 1 x CM720B power supply module all in one
and as such, each universal expander added to the system will consume the address of the corresponding single
function module.
For example if a universal expander is assigned to address 4, then you cannot assign a CM704B, CM710B or CM720B
module to address 4 and the outputs corresponding to module 4 will be provided on the universal expander as per
the table below. See the CM705B installation guide for more information.
Module
Number
Address Setting
Output Number
SW1 SW2 SW3 SW4 SW5
4 =
ON ON OFF OFF OFF
21 to 24
Table 5: Outputs Allocated To Module Address 4
