16.
Adjustments
Miter Detent System
To
avoid
possible
injury,
disconnect plug from power
source before performing any assembly,
adjustments or repairs.
Calibrating Miter Detent System
1. Engage the miter detent at the 0° position. Loosen
the miter lock knob 1/2 turn.
2. Look for four round holes in the miter scale plate.
In each hole is a screw. Use 4/6 mm hex key to
loosen all four screws 1 to 2 turns. This will loosen
the miter detent plate (see figure 11).
3. Slide the head assembly completely to the back
and engage the slide rail lock knob by tightening
the knob to the right (clockwise) (item 28 - page 9).
4. Lock saw down using the head assembly lock pin
(item 10 – page 8).
5. Hold one side of a 90° combination square against
the fence and rotate the table (and detent plate)
until the side of the saw blade plate is in full
contact with the other side of the square do not
contact the blade teeth with the sqaure (figure 12).
6. Tighten all four screws – loosen and reset the
miter scale pointer to the “0” position.
Miter Scale pointer Adjustment
1. Rotate table to 0° detent position and lock in
place.
2. Raise the head assembly to the full UP position.
3. Loosen the pointer adjust screw that holds the
miter scale pointer in place (see figure 13).
4. Position the pointer to align with the 0° line.
Tighten the screw.
Screws
Detent plate
FIG. 11
pointer
Adjust Screw
Miter Scale pointer
FIG. 13
Contacting
Fence
Contacting
Blade
Combination
Square
Set Miter
Detent at 0°
FIG. 12
WARNING
!
BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 16
