Bosch BULLS 650-185, Operating Instructions Manual

Page: 176 / 238

175
Maintenance
8.5.8.2 by.schulz suspension seat post
Only applies to
ebikes
with this equipment 1
Remove seat post from the frame.
2 Remove safety and protective cover.
3 Clean seat post on the inside and outside.
4 Examine seat post rack for scratches, cracks
and breaks.
 Replaced damaged seat post as specified in
the parts list.
 If the paint protection film is missing or has
worn away, affix a new paint protection film.
5 Lubricate screws in the parallel suspension.
6 Reinsert seat post as per height specifications
in the
ebike
pass. Check screws for correct
tightening torques.
7 Put on safety and protective cover.
8.5.8.3 Suntour suspension seat post
Only applies to
ebikes
with this equipment 1
Remove seat post from the frame.
2 Remove safety and protective cover.
3 Examine seat post rack for scratches, cracks
and breaks.
 Replaced damaged seat post as specified in
the parts list.
 If the paint protection film is missing or has
worn away, affix a new paint protection film.
4 Undo pre-tensioning adjuster and take out
steel spring.
5 Clean seat post on inside and outside.
6 Grease seat post on inside with SR SUNTOUR
no. 9170-001.
7 Lubricate pressure roller with bike chain oil.
 Lubricate articulated joints in parallel
suspension with bike chain oil.
Figure 148: SR Suntour suspension seat post lubrication
points
8 Reinsert seat post as per height specifications
in the
ebike
pass.
9 Check screws for correct tightening torques.
10 Put on safety and protective cover.

Tightening torque G1
M8 seat clamping screw
M5 fixing grub screws
20-24 Nm
3 Nm

Tightening torque G2
M6 seat clamping screw
M5 fixing grub screws
12-14 Nm
3 Nm

Tightening torque
Seat clamping screw
M5 fixing grub screws
15-18 Nm
3 Nm
1