en
Installation instructions
38
14.5 Test dishes
These overviews have been produced for test institutes to facilitate appliance testing in accordance with EN
60350-1:2013 or IEC 60350-1:2011 and EN 60705:2012, IEC 60705:2010.
Cooking with the microwave
Food
Microwave power
setting in W
Cooking time in mins Note:
Custard, 750 g
1.
360
2.
90
1.
12–17
2.
20–25
Place the Pyrex dish 20 x 25 cm
on the turntable.
Biscuit
600
8–10
Place a 22 cm diameter Pyrex
dish on the turntable.
Meat loaf
600
20–25
Place a Pyrex dish on the
turntable.
Defrosting with the microwave
Recommended settings for using the microwave to defrost food.
Food
Microwave power
setting in W
Cooking time in mins Note:
Meat
1.
180
2.
90
1.
5–7
2.
10–15
Place the Pyrex dish (22 cm dia-
meter) on the turntable.
15 Installation instructions
Observe this information when installing the appliance.
15.1 Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡
The appliance can only be used safely if it is
correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly at
its installation location
.
¡
Check the appliance for damage after
unpacking it. Do not connect the appliance if
it has been damaged in transit
.
¡
Before starting up the appliance, remove any
packaging material and adhesive film from
the cooking compartment and the door
.
¡
Never remove the transparent film on the
inside of the door
.
¡
Proceed in accordance with the installation
sheets for installing accessories
.
¡
Fitted units must be temperature-resistant up
to 90 °C, and adjacent unit fronts up to
65 °C
.
¡
Do not install the appliance behind a
decorative door or the door of a kitchen unit.
There is a risk of overheating
.
¡
Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct
operation of electrical components may be
adversely affected
.
¡
Only a licensed professional may connect
appliances without plugs. Damage caused by
incorrect connection is not covered under the
warranty
.
WARNING ‒ Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶
Wear protective gloves
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶
Do not use extension cables or multiple
socket strips.
▶
If the power cord is too short, contact Cus-
tomer Service.
▶
Only use adapters approved by the manu-
facturer.
