Bosch Benchmark SHX9PT75UC, Operating Instructions Manual

Page: 15 / 44

13
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1 Press the [On/Off] button.
2 Hold down the “ A ” button (see page 4) and press [Start] until the display indicates “ H:00 ”.
3 Release both buttons.
4 Press the “ A ” button until the display shows “ r:05 ”.
5 Press the “ C ” button to select the desired setting.
“ r:00 ” = dispenser is OFF
“ r:01 ” = lowest setting
“ r:02 ” = low setting
“ r:03 ” = medium setting
“ r:04 ” = medium/high setting
“ r:05 ” = high setting
“ r:06 ” = highest setting
6 Press [Start] to save the setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button.
2
Press the [+] button until the display jumps to “ h:01 ”.
3
Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start] to activate delay start.
To cancel delay start:
1 Press the [+] or [-] button until “ h:00 ” is indicated on the digital display.
2 Press [Start] to save setting.
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “ A ” button (see page 4) and press [Start] until the display indicates “ H:00 ”.
3 Release both buttons.
4 Press the “ A ” button until the display shows “ b:02 ”.
5 Press the “ C ” button to increase or decrease the tone “ b:00 ” = OFF and “ b:03 ” = LOUDEST
6 Press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying results. The running time may
increase slightly.
To turn intensive drying on:
1
Press the [On/Off] button.
2
Hold down the “ A ” button (see page 4) and press [Start] until the display indicates “ H:00 ”.
3
Release both buttons.
4
Press the “ A ” button until the display shows “ d:00 ”.
5
Press the “ C ” button to turn intensive drying on or off. “ d:01 ” = ON and “ d:00 ” = OFF
6
Press [Start] to save setting and close the door.