English - 4
The motor does not run:
■
The overload protection has responded.
Switch off and wait for a few seconds.
Turn the rotational direction switch 3 to the left
position (backwards) and switch the machine
back on after a short period. After the blocking
has been removed, turn the rotational direction
switch 3 back to the right position.
■
Check the power supply cord, the plug and the
house fuse.
The material to be chopped is not pulled in:
■
The spiral cutting knives are running backwards:
Switch off and change direction of rotation.
■
The material to be shredded is jammed in the
feed intake 1: Turn the rotational direction
switch 3 to the left position (backwards) and
switch the machine back on. Remove the mate-
rial from the feed intake. After the blocking has
been removed turn the rotational direction
switch 3 back to the right position.
■
Re-feed thick branches such that the knives do
not immediately grasp the pre-cut notches again.
The spiral cutting knives are blocked:
■
Turn the rotational direction switch 3 to the left
position and switch the machine on. The spiral
cutting knives will now run backwards to release
the blocked up material (or the foreign body). Af-
ter the blocking has been removed turn the rota-
tional direction switch 3 back to the right position.
Longer material standing out from the ma-
chine could lash out when being pulled in
by the knives! Please keep at safe dis-
tance!
Direction of rotation remains unchanged after
switch-over:
■
Change the direction of rotation to the desired po-
sition after the machine has come to a complete
standstill.
■
Stop and remove plug from the power supply.
☞
For safe and proper working, always keep the
machine and the ventilation slots clean.
The shredder must not be cleaned with high-pres-
sure cleaners or running water.
The tightness of the fastening screws of the under-
carriage should be checked from time to time.
To protect the machine from corrosion when storing
for a longer period, treat the spiral cutting knives with
Bosch preservation spray (accessory,
order no. 1 609 200 399). This spray is harmless to
the environment and decomposable.
If the machine should fail despite the rigorous man-
ufacturing and testing procedures, repair should be
carried out by an authorised customer service centre
for Bosch power tools.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number (typ) from the
nameplate of the machine!
Environmental label “Blue Angel”.
Awarded for extra quiet operation.
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical and
electronic equipment and its incorpo-
ration into national law, power tools
that are no longer suitable for use must be sepa-
rately collected and sent for recovery in an environ-
mental-friendly manner.
Malfunctions
Maintenance and storage
Environmental Protection
Disposal
w
eil lärmarm
J u
r y
U m w e l t z e i c h
e n
U
m
welt
zeich
en
F016 L70 438 - book.book Seite 4 Dienstag, 28. Februar 2006 3:26 15
12 • F016 L70 438 • 06.02
