en
22
Waste water pump
Large food remnants or foreign objects
which were not captured by the filters may
block the waste water pump. The rinsing
water will then be above the filter.
In this case:
–
First always disconnect the appliance
from the power supply.
–
Take out top basket
1"
and bottom
basket
1b
.
–
Remove the filters
1R
.
–
Scoop out water, use a sponge if
required.
–
Prise out the white pump cover
(as illustrated) using a spoon. Grip the
cover on the crosspiece and lift
diagonally inwards. Remove cover
completely.
–
Check impeller wheel and remove any
foreign objects.
–
Place cover in the original position and
press down until it engages (click).
–
Install filters.
–
Re-insert baskets.
... when the appliance is
switched on
The appliance does not start.
–
The mains fuse has tripped.
–
The appliance plug has not been
inserted.
–
The appliance door has not been shut
properly.
... changing settings
A setting cannot be changed, a
programme starts.
–
Wrong programme button pressed.
Terminate the programme (see chapter
entitled “Terminating the programme
(Reset)”) and start all over again.
–
You did not wait until programme
ended.
... on the appliance
Lower spray arm rotates sluggishly.
–
Spray arm blocked.
The door is difficult to open. *
–
Child-proof lock is activated. The
deactivation instructions are at the
back in the envelope.
* depending on model
Door cannot be closed.
–
Door lock has been activated. To reset,
close the door with greater force.
Cover on the detergent dispenser cannot
be closed.
–
Detergent dispenser overfilled or
mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
–
Dispenser was damp when filled.
“Check water supply” display
8
lights
up.
–
Tap turned off.
–
Water supply interrupted.
–
Supply hose kinked.
.OLFN
