Installing the AMC-4W
Access Controller AMC-4W
22
Installation Guide
Bosch Security Systems | V.3.1/2006-09
5.2.
Opening the AMC-4W Case
The AMC-4W case consists of a top cover mounted with a three-point snap-in
closure on a ground chassis. To open the AMC-4W case push the left side of
the top cover (single catch) and pull the top cover from the chassis.
Warning! Risk of damaging equipment!
Do not use screw drivers or any other sharp tools or objects to open
the enclosure. This might cause damage to the chassis..A slight
pressure with a finger is sufficient to open the enclosure.
Figure 9: Opening the AMC-4W case
5.3.
Cabling
The cables used in the AMC-4W access control system are not prone
to electrical interference. However, you should avoid routing cables
close to heavy load switching cables and equipment. If this is
unavoidable, cross the cable at right angles every 1 to 2 m (3 to 6 ft) to
reduce interference.
