Bosch Advanced Aquatak 150, Original Instructions Manual

Page: 12 / 300

12 | English
F 016 L81 291 | (13.07.2018) Bosch Power Tools
Nur für EU-Länder:
Gemäß der Europäischen Richtlinie 2012/19/EU über Elek-
tro- und Elektronik- Altgeräte und ihrer Umsetzung in natio-
nales Recht müssen nicht mehr gebrauchsfähige Geräte ge-
trennt gesammelt und einer umweltgerechten Wiederver-
wertung zugeführt werden.
English
Safety Notes
Explanation of symbols
General hazard safety alert.
Never direct the water jet at
people, animals, the machine
or electric components.
Warning: High pressure jets can be
dangerous if subject to misuse.
According to the applicable
regulations, the appliance
must never be used on the
drinking water network without a
system separator. Use a separator
as per IEC 61770 Type BA.
Water flowing though a system sep-
arator is considered not drinkable.
≥100 A
The Advanced Aquatak 150 is
intended for use only in
premises having a service cur-
rent capacity ≥100 A per phase, sup-
plied from a distribution network hav-
ing a nominal voltage of 230 V. If in
doubt please contact your Supply Au-
thority.
Safety Notes for pressure washer
Read all safety warnings
and all instructions.
Failure
to follow the safety warnings
and instructions may result in electric
shock, fire and/or serious injury.
The warning and information signs
attached to the unit provide import-
ant information for safe operation.
Apart from the information in the
operating instructions comply with
the general safety regulations and
regulations for the prevention of ac-
cidents.
Connecting to the mains
u
The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
u
We recommend that this equipment
is only connected into a socket
which is protected by a circuit-
breaker that would be actuated by a
30 mA residual current.
u
The circuit breaker supplying mains
power to the high-pressure washer
should have no less than a C16 rat-
ing. If in doubt consult a qualified
electrician for further advice. Do not
attempt to modify your electrical
system yourself.
u
Remove the plug from socket
whenever the machine is left unat-
tended for any period.
u
The electric supply installation
should comply with IEC 60364-1.