Bosch 3600HB0004, Original Instructions Manual

Page: 29 / 318

English | 29
Problem Possible Cause Corrective Measure
Rough mowing conditions Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Flatten garden/remove/bumps/mark out unsuitable
areas with the perimeter wire – Please follow the instruc-
tions in the Installation Guide.
Grass too long Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Slopes in garden too steep Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope.
Mower gets stuck in
garden Objects/obstacles not marked out Use the perimeter wire to mark off obstacles where the
mower often gets stuck.
Newly laid turf Allow a few weeks for the soil to settle before using the
mower.
Change setting in menu item "lawn condition / bump
sensor" to low sensitivity / uneven.
After watering, wait as long as possible until you start the
mower.
Mower unintentionally
cuts flowers, etc. or
runs over certain
obstacles Objects/obstacles below 5 cm not marked
out Mark obstacle using perimeter wire leaving 30 cm from
object or remove objects/obstacles.
Mower does not ap-
pear to cut logically LogiCut system depends on the garden
conditions. Mower does not necessarily
have to continue in the next uncut area. Further information can be found on the Installation
Guide.
If behaviour re-occurs often, remap lawn area.
Mower does not always go in a straight line
when travelling between areas No corrective action needed.
Mower frequently does not find right posi-
tion or turns on the spot Change wire ID.
Wire crossed while marking an object Follow instructions in the Installation Guide.
Mower runs in random paths in an addi-
tional lawn without docking station. Normal behaviour. The LogiCut system only works in
areas with docking station.
Perimeter wire keeps
being cut Wire is not taut between pegs
Distance between pegs is more than 75 cm
Make wire taut and ensure distance between pegs is
maximum 75 cm. Use the wire connectors to repair the
cut. Avoid using a verticutter, scarifier, etc. over the peri-
meter wire.
Mower leaves ragged
finish/poor quality of
cut The mower does not mow often enough Mow more frequently for a good result (e.g. by means of
more/longer slots in schedule).
Cutting blades blunt Reverse or replace cutting blades (see figure J ).
Possible clogging Always turn isolator switch off first, then check under-
neath the mower. Clear out as necessary (always wear
protective gloves).
Perimeter wire not
detected No power at the docking station Check if the docking station is powered up (LED is on).
Perimeter wire damaged/cut Check perimeter wire for damage.
Wrong installation (e.g. not enough dis-
tance between wires) Follow instructions in the Installation Guide.
Perimeter wire close to a source of interfer-
ence Remove any excess (e.g. coiled up) perimeter wire
around the docking station. Change perimeter wire ID in
the menu.
Bosch Power Tools F 016 L94 037 | (11.11.2020)