-8-
CUP GRINDING WHEELS
Use cup grinding wheels for heavy-duty stock
removal of metals, concrete and stone.
ADJUSTABLE CUP
WHEEL GUARD INSTALLATION
Open the guard clamp and fit it on the
mounting flange then secure by tightening
the clamp screw. ALWAYS HAVE THIS
GUARD ATTACHED WHEN USING CUP
GRINDING WHEELS
The adjustable guard allows you to lower or
raise the guard’s shell. TO ADJUST: Loosen
the four bolts on the shell, and secure the
shell for 1/4” wheel exposure for maximum
safety.
ATTACHING CUP GRINDING WHEEL
Thread the cup grinding wheel on the spindle
shaft CLOCKWISE. Press in the spindle lock
button and turn the cup grinding wheel until
the lock button engages, then tighten the
wheel securely by hand.
TO REMOVE: Reverse procedure.
LOCK NUT AND BACKING FLANGE
Your tool is equipped with a threaded spindle
for mounting accessories. Always use the
lock nut and backing flange that has same
thread size as spindle.
DISC GRINDING WHEEL ASSEMBLY
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
When using spin-on grinding wheels, thread
directly onto the spindle.
When using mounting wheels, thread
BACKING FLANGE onto spindle, then place
GRINDING WHEEL on the spindle. Thread
on the lock nut and tighten nut using a lock
nut wrench provided with adapter kit, while
holding the spindle lock in.
TO REMOVE: Reverse procedure.
SIDE HANDLE
The side handle used to guide and balance
the tool can be threaded into the front housing
on either side, and on top of the tool,
depending on personal preference and
comfort. Use the side handle for safe control
and ease of operation.
Always use auxiliary
handle for maximum
control over torque reaction or kick-back.
Operation of the grinder without the side
handle could cause loss of control of the
grinder, resulting in possible serious personal
injury.
!
WARNING
BACKING
FLANGE
LOCK NUT
WHEEL
GUARD
DISC
GRINDING
WHEEL
SPIN-ON GRINDING
WHEEL
SPINDLE
MOUNTING
FLANGE
BOLT
ADJUSTABLE
GUARD
CUP
GRINDING
WHEEL
SHELL
SPINDLE
MOUNTING
FLANGE
BM 1609929H55 1-05 1/5/05 3:17 AM Page 8
