14
1
2
3
1
2
24
1
2
3
1
2
Fig. 8
Fig. 9
Fig. 10
CHANGING DRIVE
SOCKET ON THE
ANGLE HEAD WITH
EXTERNAL SQUARE
DRIVE
Inserting
– Press in the pin on the
square drive of the angle
head
2, e. g. using a small
screwdriver, and slide the
drive socket
1 over the
square drive. Pay attention
that the pin engages in the
recess of the tool bit (Fig.
8).
Removing
– Press in the pin on the
square drive through the
hole on the side of the
drive socket, then pull the
socket off the square drive
of the angle head
2 (Fig. 8).
CHANGING DRIVE
BIT ON THE ANGLE
HEAD WITH INTERNAL
HEXAGON
Inserting
– Insert the tool bit
1 into the
internal hex socket of the
tool holder
2 until it can be
felt to engage (Fig. 9).
Removing
– Pull the tool bit
1 off of the
tool holder
2 with the aid of
pliers, if necessary (Fig. 9).
CHANGING DRIVE BIT
ON THE ANGLE HEAD
WITH QUICK-CHANGE
CHUCK
Inserting
Use only insertion tools with
fitting end pieces (1/4” hex-
agonal) .
– Pull the sleeve of quick-
change chuck
24 to the
front and hold (Fig. 10).
– Insert tool bit
1 into tool
holder
2 and release the
quick-change chuck (Fig.
10).
Removing
– Pull the sleeve of quick-
change chuck
24 to the
front and hold (Fig. 10).
– Remove tool bit
1 from tool
holder
2 and release the
quick-change chuck (Fig.
10).
160992A3VR.indb 14
3/7/17 12:22 PM
