01/20
B2003T
Made in China to TQB Brands Pty Ltd specifications
P a g e
|
4
Visit us at www.tqbbrands.com.au
4.
OPERATION
Prior to each use always conduct a visual inspection checking for and any abnormal conditions, such
as cracked welds, and damaged, loose, or missing parts.
Raising the Jack:
1.
Block the vehicle's wheels for lifting stability. Secure the load to prevent inadvertent shifting and
movement.
2.
Position the jack on a hard and level surface near desired lift point.
3.
Set the parking brake in the vehicle.
4.
Refer to the vehicle manufacturer owner's manual to locate approved lifting points on the vehicle.
Position the jack so the saddle is centred and will contact the load lifting point firmly
5.
Close the release valve by turning it clockwise until firmly closed.
6.
Connect compressed air supply to the jack. (Compressed air should be clean, dry, and regulated
at 100-120psi). Install an air filter/lubricator in the workshop air-line, because water in the airline
will damage the jack.
7.
Before raising the vehicle, double check and verify the saddle is centred and has full contact with
the specified lifting point.
8.
Squeeze the air trigger to lift until the saddle contacts the load. (To stop air operation, simply
release the grip on the lift control trigger). Continue to pump the jack to lift the vehicle to the
desired height.
9.
Always immediately position approved jack support stands under the vehicle at points that will
provide stable support in accordance with the vehicle manufactures recommendations.
10.
Always lower the vehicle slowly onto the jack stands by pushing the control lever to the DOWN
position.
11.
Carefully lower the load onto the jack support stands by turning the release valve knob on the
end of the handle counter clockwise.
WARNING
Never wire, clamp or otherwise disable the lift control valve to function by any means other than by
using the operator's hand. Use the handle provided with this product or an authorised replacement
handle to ensure proper release valve operation. Do not use extensions on the air hose or on the
operating handle.
To Lower Vehicle:
1.
Raise the load by following Steps 5-9
2.
Raise the vehicle high enough to allow clearance for the jack support stands to be removed by
squeezing the air trigger.
3.
Carefully remove the jack support stands
4.
Grasp the jack handle firmly. Securely hold onto the jack handle so that your hands do not slip
and ensure the release valve does not lower rapidly.
5.
Carefully open the release valve by slowly turning the knob on the handle counter clockwise.
6.
Once the load has been lowered, remove the jack from beneath the vehicle, fully retract the ram
to minimise exposure to dirt and grime.
5.
MAINTENANCE
If you use and maintain your equipment properly, it will give you many years of service. Monthly
maintenance is recommended. Lubrication is critical to jacks as they support heavy loads. Any
restriction due to dirt, rust, etc, can cause either slow movement or cause extremely rapid jerks
damaging the internal components.
The following steps are designed to keep the jack well maintained and operational.
