- 3 -
4. Making sure hands are clear, CLOSE TOP and
stand desk upright. Attach stringers (Item 4) with
four (4) nuts and screws (Items 6 & 7) - two (2)
each side - in the bottom holes on the inside of
the leg assembly. See Figure 3. Finger tighten
only.
FIGURE 3
5. Attach shelf (Item 5) to the stringers in the front
and to the leg assemblies in the rear with four (4)
nuts and screws (Items 6 & 7) - two (2) each side
as shown. See Figure 4. Finger tighten only.
6. Position rack assembly (Item 2) on top of desk,
align holes and fasten together with four (4) sheet
metal screws (Item 8) as shown. See Figure 5.
Tighten with a Phillips screwdriver.
7. Insert rubber bumpers (Item 9) into slots on the
side edges of the desk. See Figure 5.
C A U T I O N
VERY IMPORTANT - Move desk into workstation position and level.
TIGHTEN ALL SCREWS and NUTS with a 1/2" wrench and a Phillips screwdriver.
8. Insert lock (Item 10) into lock hole in desk front. Open top and slide snap fastener over lock, securing it in place. Close
top. Insert key and test locking capability.
C A U T I O N
MAKE SURE ALL HANDS AND FINGERS ARE CLEAR BEFORE CLOSING TOP.
DO NOT LEAVE OPEN AND UNATTENDED.
DO NOT WEDGE OPEN.
FIGURE 4
FIGURE 5
SHEET METAL
SCREWS
RUBBER
BUMPER
NUT
STRINGER
SCREW
SCREW
NUT
SCREW
