Borri B9600FXS, Product Manual

Page: 53 / 65

OMD39088 rev F
52
5.3.2 Bypass insulation transformer
It is used when the input line is without neutral, or the galvanic isolation between the
mains and the loads is required.
During normal operation the inverter transformer provides for this task, while during
the bypass condition the mains feeds the load directly. Generally the insulation
transformer is used when the output neutral conductor must be different from the input,
thus discriminating two different grounding systems.
5.3.3 Voltage adaptation transformers
A voltage adaptation transformer can be connected at the UPS output terminals to
adapt the standard output voltage to the value requested by the loads. It can also be
connected at the input terminals to adapt the actual mains voltage to the values defined
in the technical specification. In case the galvanic isolation is not required an auto-
transformer can be used.
5.3.4 Alarm card SRC (ALARM RELAY CARD)
Card SRC is an interface used to make the main UPS statuses and alarms available
on volt free contacts (NO/NC switching contacts).
During normal operation, without alarms, all the relays are energized.
Relay Alarms/Status Status
M1 Led
Pins Status Name Status
RL1 Alarm = General alarm
Not
energized
2-3
Open
D1 Off
1-2
Closed
RL2 Alarm = Mains fault
Not
energized
5-6 Open
D2 Off
4-5 Closed
RL3 Alarm = Battery low
Not
energized
8-9
Open
D3 Off
7-8 Closed
RL4 Alarm = Inverter out of tolerance
Not
energized
11-12 Open
D4 Off
10-11
Closed
RL5 Alarm = Bypass feeds load
Not
energized
14-15
Open
D5 Off
13-14 Closed
RL6 Status = Booster OK Energized
17-18 Closed
D6 On
16-17
Open
RL7 Status = Inverter feeds the load Energized
20-21
Closed
D7 On
19-20 Open
RL8 Status = Bypass OK Energized
23-24 Closed
D8 On
22-23
Open
Relay specification:
Voltage 120 VAC Current 1A
Voltage 50 VDC Current 1A DC1
The package contains:
-
interface card SRC
-
4 plastic nuts for the installation
- installation and user manual