BorMann Pro BBS1560, User Manual

Page: 4 / 13

EN
WWW.BORMANNTOOLS.COM
4
IV. Changing the sanding discs
V. Changing the sanding belts
WARNING :
TURN THE POWER OFF AND REMOVE THE PLUG FROM THE OUTLET BEFORE CHANGING THE ACCESSORIES.
CAUTION :
‘HOOK & LOOP’ SANDING DISCS CANNOT BE USED WITH THIS SANDER!
CAUTION :
Check the inside of the belt for a "direction arrow". If present, install the belt with the arrow pointing in the same direction as the direction
indicator on the housing.
1. Remove mitre gauge and work table assembly.
2. Remove the disc guard screws and disc guard.
3. Remove sanding disc from disc plate. Sanding discs are attached to the plate using a
pressure- sensitive adhesive
4. Ensure the disc plate is clean.
5. Peel backing away from the new sanding disc.
6. Align perimeter of disc with plate and press disc firmly into position on plate, leaving
no loose edges.
7. Replace the disc guard, disc guard screws and work table.
1. Loosen the socket head screw using the 6 mm hex wrench provided.
2. Raise the belt sanding arm as shown.
3. Slide out one end of the tension lever as shown to release belt tension.
4. Remove the tray located on the bottom of the belt sanding arm by loosening the two
screws on the back of the belt sanding arm.
5. Slide the sanding belt off of the drive and idler drums.
6. Slide new sanding belt over the drive and idler drums. Ensure the belt is centred on
both drums and is the right way round.
7. Return the tension lever into its original positiom to apply tension to the belt.
8. Replace the tray and tighten the two screws on the back of the belt sanding arm.
9. Lower the belt sanding arm and tighten the socket head screw using the 6mm hex
wrench provided.
10. Before using, check belt tracking as described in the next section and adjust as nec
-
essary.