BorMann PRO BAT1350, Manual

Page: 2 / 4

EN
WWW.BORMANNTOOLS.COM
2
This air inflating gun is Ideal for air checking, air inflating and air releasing for all different wheels of cars.
Intended use
Technical Data
Safety instructions
Operating instructions
Working pressure: 2-6BAR
Gauge pressure: 0-18BAR
Gauge precision: ±1PSI
Gauge units: PSI, BAR, KPA
Warning!
1. Check and make sure the air inflating gun is well before working.
2. Sealing gasket, O-ring and rubber pipe part,if find any deformation or damage must be changed
3. As some components of this air inflating gun are made of plastic,they cannot be touched with medium of acid and base,to avoid any corrosion damage.
4. Ordering to keep healthy an safety, if the noise lever is higher than 185dB(A), it’s necessary to use earplug.
5. To make safety, during work it should release the trigger discontinuity to check pressure whether meet request pressure of tire using, avoid any damaged of
tire because of high pressure.
Figure 1
1. Before operation, check whether the tire pressure gun is in good condition, and whether the trigger and
bayonet rotation are flexible.
2. Connect the compressed air source to the air inlet of the tire pressure gun (shown in Figure 1).
3. Insert the nozzle of the tire pressure gun onto the valve core of the tire to be inflated (as shown in Figure 1),
press the opening key on the left side of the tire pressure gauge to display the pressure, press the switch on the
right side.
4. Pull the trigger to the end to achieve the purpose of inflation. At this time, the pressure gauge shows the value
is “0” (shown in Figure 2).
5. After filling a certain amount of air, release the trigger and check the pressure gauge to see if the value reaches
the required pressure (The pressure gauge shows the internal pressure of the tire after inflation).
6.1 When the displayed air pressure is low, continue to inflate the tires by following steps 4 and 5.
6.2 When the displayed air pressure is high, gently pull the trigger (feel the air is leaking at the valve stem,
pressure gauge.
The pointer will slowly drop, you can't pull the trigger to the end) and deflate until the pressure gauge shows
The value reaches the required pressure (shown in Figure 3).
7. After the operation is finished, disconnect the air compression source, remove the bayonet from the valve
core.
Figure 2
Figure 3
* The manufacturer reserves the right to make minor changes to product design and technical specifi -
cations without prior notice unless these changes significantly affect the performance and safety of the
products. The parts described / illustrated in the pages of the manual that you hold in your hands may also
concern other models of the manufacturer's product line with similar features and may not be included in
the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial appli -
cations. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or
for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair
or replacement work, including maintenance and special adjustments, must only be carried out by techni -
cians of the authorized service department of the manufacturer.
Remove the rubber housing in order to insert the supplied batteries into the tool's battery compartment after
unpacking the tool.